Step2: Connect an external device
1. DIGITAL IN connection
Connect an external device with a digital optical cable or
digital coaxial cable. Note that this unit is equipped with an
"Opt1Wakeup feature" so that when play starts on an
external device connected to the OPTICAL 1 (GAME)
terminal, this unit comes on and the INPUT SELECTOR
automatically changes. (P32)
0 The default setting for "Opt1Wakeup feature" is "Off". To
enable this function, press SETUP on the remote
controller, then in the Setup menu displayed set "3.
Hardware" - "Opt1Wakeup" to "On". (P32)
0 Only PCM audio is supported for input through the
DIGITAL IN OPTICAL/COAXIAL jacks. Set the audio
output on the external device to output PCM.
> Before Start > Part Names >Install > Initial Setup > Playback
Supplementary information | Advanced Setup | Others
To Next Page
Loading...
