24
Speaker Placement
—Continued
Main room A: 5.1 ch speaker system including the front speakers connected through the BTL or bi-
amp connections
• For speaker system [A], set the surround back speaker parameters to “BTL for Front ” or “Bi-Amp for Front” and all
the other speaker parameters to “Main A” (For details on speaker connections, see page 27).
• For speaker system [B], set the speaker parameters to “Not Used.”
*When using the BTL or bi-amp connections, you cannot use Zone 2 since the surround back channel is used for the front speakers of
main room A.
Main room A: 7.1 ch from the speaker system [A] and additional subwoofer and surround speakers
from speaker system [B] (suitable for enjoying more powerful and lively surround sound in main
room A); Main room B: two front speakers from speaker system [B] using the BTL or bi-amp
connections
• For speaker system [A], set all the speaker parameters to “Main A.”
• For speaker system [B], set the surround speaker and subwoofer parameters to “Main A,” the front speaker
parameters to “Main B,” and the surround back speaker parameters to “BTL for Front” or “Bi-Amp for Front” (For
details on speaker connection, see page 27).
• When you want to use the surround speakers and subwoofer of speaker system [B] for specific sources, select the
source and set the parameters for these speakers to “B” or “A+B” in the listening mode setup menu.
When you set the parameter to “B,” the audio signal comes out from the surround speakers and subwoofer of
speaker system [B]. When you set the parameter to “A+B,” the signal comes out from the surround speakers and
subwoofer of both speaker systems [A] and [B].
FL
C
SW
FR
SR
SL
Main room A
To Next Page
Loading...
