Onkyo TX-NR1000

85
Setup Menu —Continued
OSD Map (ZONE 2)
Zone 2 Setup
=====================
0.Hardware Setup
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Audio Adjust
5.Preference
Zone 2 Setup
=====================
0.Hardware Setup
2.Input Setup
3.Listening Mode Setup
4.Audio Adjust
5.Preference
0.Hardware Setup
=====================
1.TV Format Setup
1.Speaker Setup
=====================
1.Speaker Impedance
2.Input Setup
==Input:XXXXXXXXX====
1.Listening Mode Preset
2.Delay
4.Audio Adjust
=====================
1.Tone Control
5.Preference
=====================
1.Volume Setup
2.OSD Setup
3.OSD Position
3.Listening Mode Setup
=====================
1.Mono Setup
2.Multiplex Setup
3.Stereo Setup
4.Dolby Digital Setup
5.DTS Setup
6.AAC Setup
7.Dolby Virtual
Speaker Setup
(Main menu 1)
The Zone 2 settings shown on this
page can be made when you
perform either of the following
settings in the “MAIN A” setup
menu.
• Under the “Speaker/Output
Setup → Speaker Configuration”
menu, when you select the
surround back setting to
“Powered Zone 2.” (The main
menu 1 below)
• Under the “Speaker/Output
Setup → Audio (Video) Output
Assign” menu, when you select
the output terminal setting to
“Zone 2 Out.” (The main menu 2
below)
(Main menu 2)
87
89
96
98
99
100
106
108
109
116
118
119
Reference
pages