Onkyo TX-NR1000

61
Listening to Radio Broadcasts —Continued
Presetting a Radio Station
Up to 40 stations can be stored in memory as preset radio
stations.
Selecting a Preset Radio Station
When using the TX-NR1000/TX-NR5000E:
When using the remote controller:
Erasing a Preset Radio Station
1
Tune into the radio station you
desire (See “Tuning Into a Radio
Station”).
2
Press the [MEMORY] button on the
front panel.
3
Using the [SELECT/PRESET] dial,
select a preset number (from 1 to
40) to assign the station.
The “MEMORY” indicator blinks for 5
seconds. Complete the procedure while
the “MEMORY” indicator blinks. If the
“MEMORY” indicator disappears
before completing the procedure, go
back to step 2 and repeat the procedure
again.
4
Press the [MEMORY] button to
finalize the procedure.
You can enter text names for any of the
preset radio stations (See page 97).
STANDBY/ON
STANDBY
PURE AUDIO
MASTER VOLUME
OPEN
ZONE 2
()
GREEN
MAIN
()
BLUE
REC / ZONE 3
(
)
RED
DISPLAY
DVD VIDEO
3 VIDEO 4 VIDEO 5 VIDEO 6 VIDEO 7VIDEO 2VIDEO 1
TUNING
MODE
MEMORY
SETUP
EXIT
PHONES
VIDEO 7 INPUT
S VIDEODIGITAL AUDIO
VIDEO L R
LISTENING
MODE
AUDIO
SELECTOR
TONE
CLEAR
DIMMER
ZONE
2 REC/ ZONE 3
LEVEL LEVEL
SELECT/
PRESET
CONTROL
/ TUNING
PUSH TO ENTERPUSH TO ENTER
C D NET AUDIOPHONOTUNERTAPE 1 TAPE 2
TUNING MODE
MEMORY
TUNER
SELECT/PRESET
TUNING
MODE
MEMORY
Flashes
SELECT/PRESET
TUNING
MODE
MEMORY
Lights
1
Press [TUNER] input source but-
ton on the TX-NR1000/
TX-NR5000E.
2
Using the [SELECT/PRESET] dial,
select the number of the desired
preset station.
1
Press the [INPUT] button, and then
use the scroll wheel to select
TUNER.
To switch to FM or AM, press the scroll
wheel.
2
Use the [CH/DISC +/–] button to
select the presets.
Selecting Presets by Number
To select a preset by number, use the
remote controller’s number buttons. For
example, to select preset #7, press [7].
To select preset #12, press [1] then [2].
1
Press the [TUNER] input source
button and use the [SELECT/PRE-
SET] dial to select the preset radio
station that you want to erase (See
above).
2
Press and hold the [MEMORY] but-
ton and then press the [TUNING
MODE] button.
The selected preset station is erased.
TUNER
SELECT/PRESET
INPUT
CH
DISC
+
-
TUNER
SELECT/PRESET
TUNING
MODE MEMORY