Onkyo TX-NR5100 - Page 113

113
SetupSetup
5. Hardware
 Bluetooth Wakeup (Default Value: O󰀨)
This function wakes up the unit on standby by connecting a BLUETOOTH
enabled device.
On When this function is used
• When this function is set to "On", the power consumption
in standby state increases, however, the increase in power
consumption is minimized by automatically entering the
HYBRID STANDBY mode where only the essential circuits
operate.
O󰀨 When this function is not used
• This setting is xed to "O󰀨" if "Bluetooth" -"Bluetooth
Receiver" is set to "O󰀨".
• This setting is also xed to "O󰀨" if "Bluetooth" - "Bluetooth
Receiver" - "Auto Input Change" is set to "O󰀨".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be
selected. It can be selected when the network function is activated.
 5. Works with SONOS
Change the settings to connect with the Sonos Connect.
 Input Selector (Default Value: O󰀨)
Select the input selector to which the Sonos Connect is connected.
• Selecting "O󰀨" disables the interlock function with Sonos.
 Connected Device (Default Value: -)
Displays the Sonos Connect connected to the same network as the network of
this unit. Press the ENTER button to select the connected Sonos Connect.
• Products (e.g. Play:3 unequipped with an output terminal) other than the
Sonos Connect are also displayed in the device list and selectable. In
that case, when playback on the Sonos side starts, the input is switched,
however, audio is not output. Select the room name of the connected Sonos
Connect.
• Up to 32 devices can be displayed on the Sonos product list screen. If you
cannot nd the Sonos Connect to be interlocked, return to the previous
screen, turn o󰀨 the product you do not want to interlock, and try again.
• To use this function, set "Input Selector" beforehand.
 Preset Volume (Default Value: Main=Last)
You can set the volume beforehand for playing back the Sonos Connect.
Select a value from "Last" (Volume level before entering standby mode), "Min",
"0.5" to "99.5" and "Max".
• To use this function, set "Input Selector" beforehand.