Onkyo TX-NR5100 - Page 114

114
SetupSetup
6. Miscellaneous6. Miscellaneous
 1. Tuner
Change the settings for Tuner.
 AM / FM Frequency Step (Default Value: 10 kHz / 0.2 MHz)
Select a frequency step to suit your residential area.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets are deleted.
 2. Remote ID
Change the remote controller ID.
 Remote ID (Default Value: 1)
If multiple ONKYO products are installed in the same room, select the ID
for the remote control used with this unit from "1", "2" and "3" to prevent
interference between the unit and other ONKYO products. After changing the
ID on the main unit, set the same ID on the remote controller as the main unit
with the following procedure.
While pressing and holding the MODE button, press the following buttons for
approx. 3 seconds.
• To change the remote controller ID to "1": MOVIE/TV
• To change the remote controller ID to "2": MUSIC
• To change the remote controller ID to "3": GAME