Onkyo TX-NR5100 - Page 50

50
Connections
Connecting an AV Component in a Separate Room (ZONE B connection)
Connecting an Integrated Amplier (ZONE B)
While performing playback in the main room (where this unit is located), you can
enjoy 2-ch audio of the same source in the separate room (ZONE B) at the same
time. Use an analog audio cable to connect the ZONE B PRE/LINE OUT jack of
this unit to the LINE IN jack of the integrated amplier or power amplier in the
separate room.
Setup
• When connecting the power amplier, set "Zone B Output Level" to "Variable"
for "Speaker Setup" in the Initial Setup section ( →p117). When setting
"Zone B Output Level" from the Setup menu, press on the remote
controller, and set "2. Speaker" - "Conguration" - "Zone B Output Level"
( →p96) to "Variable". If it is not set, a large volume is output and the power
amplier, speakers, etc. may be damaged.
a
Input
Terminal
Integrated
amplier
a Analog audio cable