EasyManua.ls Logo

Onkyo TX-SR574

Onkyo TX-SR574
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
First Time Setup
—Continued
6
Use the Down [ ] button to
select “Surround, and then use
the Left and Right [ ]/[ ] but-
tons to select
Small
,
Large
, or
None
.
Small:
Select if the surround speak-
ers are small.
Large:
Select if the surround speak-
ers are large.
None:
Select if no surround speakers
are connected.
Note:
If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
7
Use the Down [ ] button to
select “Surr Back, and use the
Left and Right [ ]/[ ] buttons to
select
Small
,
Large
, or
None
.
Small:
Select if the surround back
speakers are small.
Large:
Select if the surround back
speakers are large.
None:
Select if no surround back
speakers are connected.
Notes:
If the Surround setting in step 6 is set
to None, this setting does not appear.
If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
8
Use the Down [ ] button to
select “Surr Back Ch, and use
the Left and Right [ ]/[ ] but-
tons to select
2ch
or
1ch
.
2ch:
Select if two (left and right)
surround back speakers are
connected.
1ch:
Select if one surround back
speaker is connected.
Note:
If the Surround and Surr Back set-
tings in steps 6 and 7 are set to None,
this setting does not appear.
9
Press the [SETUP] button.
Setup closes.
SETUP
Testing the Speakers
To test that all of the speakers are working properly,
press the remote controller’s [TEST TONE] but-
ton.
The test tone will be output by each speaker in turn
and the name of each speaker will appear on the dis-
play. To turn off the test tone, press the [TEST
TONE] button again.
If the test tone is not produced by a speaker, or it’s
produced by a speaker other than that shown on
the display, you may have wired the speakers
incorrectly and you should check your connec-
tions (see page 17).
If the test tone is not produced by a speaker and its
name does not appear on the display, you may
have set the speaker configuration incorrectly (see
page 35).
•Testing cannot be performed while speaker set B
is on or a pair of headphones is connected.
RANDOM
SUBTITLE
PLAY MODE
AUDIO REPEAT
RC
-
647M
HDDDVD
VCR
LISTENING MODE
DISPLAY
TEST
TONE
CH SEL
SURROUND
STEREO
CINE FLTR
LEVEL
+
LEVEL
-
L NIGHT
TEST
TONE
TX-SR574En.book Page 36 Wednesday, April 5, 2006 5:14 PM

Table of Contents

Other manuals for Onkyo TX-SR574

Related product manuals