Onn 100043839 - Basic Operation; Powering On and Off; Auto Wake and Auto Power Off

12
1. Unplug both units from the mains
sockets again, then plug them in
again after 3 minutes.
2. Press and hold the PAIR button
on the rear of the Subwoofer or
Surround for a few seconds. The
Subwoofer or Surround will enter
the pairing mode and the Pair
Indicator will blink quickly.
3. Press the
button on the main unit
or on the remote control to switch
the main unit on.
4. The Pair indicator on the
Subwoofer or Surround will
become solid when successful.
5. If the Pair indicator blinks, the
wireless connection has failed.
Unplug the cable of the Subwoofer
or Surround and then reconnect
the main cable after 4 minutes.
Repeat step 1 ~ 4.
Tips:
• The Subwoofer&Surround should
be within 6 m of the Sound Bar
in an open area (the closer the
better).
• Remove any objects between
the Subwoofer&Surround and the
Sound Bar.
• If the wireless connection fails
again, check if there is a conict
or strong interference (e. g.
interference from an electronic
device) around the location.
Remove these conicts or strong
interferences and repeat the
above procedures.
• If the wireless connection fails
again, check if there is a conict
or strong interference (e. g.
interference from an electronic
device) around the location.
Remove these conicts or strong
interferences and repeat the
above procedures.
• If the main unit is not connected
with the Subwoofer / Surround
and it is in ON mode, the Pair
Indicator on the Subwoofer /
Surround will blink slowly.
Basic Operation
Standby/ON
When you rst connect the main unit
to the mains socket, the main unit will
be in Standby mode.
Press the
button on the unit or on
the remote control to switch the unit
ON.
Press the
button again to switch the
unit back to STANDBY mode.
Disconnect the mains plug from the
mains socket if you want to switch the
unit OFF completely.
Auto Wake
If a TV or an external device is
connected, the unit will switch on
automatically when the TV or the
external device is switched on.
Automatic Power Off Function
The unit automatically turns to
Standby mode after about 15 minutes
if the TV or the external unit is
disconnected, switched off.
To switch the unit off completely,
remove the mains plug from the mains
socket.