Initial Setup and Operation of OnStep
Initial Positioning
Assumed Starting Position: OnStep assumes the telescope is initially pointed
horizontally toward due north (Note: This refers to geographic north, not the
celestial pole).
Manual Positioning: Move the telescope to this position manually, ensuring it is
in manual mode and the motor drive is unclutched.
Using the Smart Hand Controller:
o Enable tracking.
o Utilize the HandPad buttons (E/W/N/S) to maneuver the scope to the
desired position.
o If the minimum altitude limit is reached before achieving a horizontal
position, you may power off the controller, manually adjust the telescope
further, and then power it back on.
Using "Park" and "Unpark" Features
o Parking: Always “Park” your telescope after use, especially if situated in
an observatory, to preserve its position.
o Unparking: On your next use, simply select “Unpark” to resume from the
stored position without requiring realignment.
o
Alignment and Further Instructions
Detailed instructions for alignment and other advanced features are available through
the following resources:
32
To Next Page
Loading...
