74 Operation
Falcon+ Operator Manual
OPEX Corporation
subsequent pieces will be noted. It also indicates how the batch will be noted.
Since the RefIDs for a batch are not finalized until the batch is closed, batch
RefIDs may be changed at any time. Page RefIDs, however, may only be
changed by rescanning the piece in question.
ScanLink This panel is controlled by the ScanLink plug-in for the running job.
This panel is not visible if a plug-in is not defined.
WholesaleWorks 0 This panel is controlled by the ScanLink plug-in for the
running job. This panel is visible if the plug-in requests it. This panel is also
labeled by the plug-in.
WholesaleWorks 1 This panel is controlled by the ScanLink plug-in for the
running job. This panel is visible if the plug-in requests it. This panel is also
labeled by the plug-in.
To Next Page
Loading...
