84 Operation
Falcon+ Operator Manual
OPEX Corporation
4.3.9. Rescanning Items
There are a couple reasons and methods for rescanning items:
Getting a Better Image If you are not pleased with a particular image, you
can rescan the item while the job is running. CertainScan has a Rescan button
that allows you to replace a poor image or item scanned out of order by using
the normal feeder. Steps for this method are described below.
Multi-Feed Reject After a multi-feed reject, the feeder and conveyor will
stop, a jam dialog will appear on screen, the Rescan Feeder LEDs will flash
blue, and the Pre-Feed MFD Override LED will flash green. The flashing in
these two areas alerts you that either one may be chosen to re-feed the reject:
- Rescan Feeder - The Falcon+ Rescan Feeder is a mechanism that
allows the operator to feed a single or multiple items into the machine
which had been rejected or the auto-feeder is not able to feed. See
“About the Rescan Feeder” on page 85
for more details.
- Pre-Feed - The Falcon+ has another entry point at which the operator
can interject rejected sheets: this entry point is in the Pre-Feeder
mechanism and is primarily designed for multiple rejects to be stacked;
alleviating the need to insert them one at a time. See “About the Pre-
Feeder Mechanism” on page 88 for more details.
To Rescan an Item:
1. Select the item’s thumbnail.
2. Take the item out of the sort bin.
3. Press
Rescan
to replace the item in the batch.
Note: If an audit trail was printed on the item the first time it was scanned, you
may press
Rescan NP
(no printing) to replace the item in the batch. This way,
no additional audit trails will be printed on the item.
4. Drop the item onto the conveyor.
5. Verify that the image is acceptable.
Note: The Rescan buttons will only be available if activated in the batch
parameters.
To Next Page
Loading...
