Operation 103
Falcon+ Operator Manual
OPEX Corporation
Scheme 1 Mapping for “WholesaleWorks” jobs
If the job’s General Job Parameters > Job Type parameter is set to either Wholesale-
Works Generic or WholesaleWorks Specific, the keys are mapped as follows. Note
that the presence and contents of “Tab0” and “Tab1” are dictated by the
ScanLink plug-in used by the job in question:
Scheme 2 Mapping for “Generic” jobs
If the job’s General Job Parameters > Job Type parameter is set to Generic, the keys
are mapped as follows (Note that some mapping are double presses. For
example, 0,1 indicates pressing 0 and then 1 in quick succession):
Key Function
1-8
selects page types 1 through 8
(and page sub-types 1-8, when the sub-type dialog is displayed)
9 Solicit Custom Data ScanLink Call
0 selects a new transaction
+ starts/stops the track
/ rotates the piece 90 degrees clockwise
* rotates the piece 180 degrees
-
flips the front and back images
(if the page type is set up to scan front and back images)
Key Function
1-8
selects page types 1 through 8
(and page sub-types 1-8, when the sub-type dialog is displayed)
9 Solicit Custom Data ScanLink Call
0 selects a new transaction
+ starts/stops the track
/ no action
* Toggle popup of “Tab 0”
- Toggle popup of “Tab 1”
To Next Page
Loading...
