Opex Falcon+ - Page 208

104 Operation
Falcon+ Operator Manual
OPEX Corporation
Scheme 2 Mapping for “WholesaleWorks” jobs
If the job’s General Job Parameters > Job Type parameter is set to either Wholesale-
Works Generic or WholesaleWorks Specific, the keys are mapped as follows. Note
that the presence and contents of “Tab0” and “Tab1” are dictated by the
ScanLink plug-in used by the job in question (Note that some mapping are
double presses. For example, 0,1 indicates pressing 0 and then 1 in quick
succession):
Key Function
0,1 -
1,2
selects page types 1 through 12
1 - 9 when the sub-type dialog is displayed, selects page sub-types 1-9
7,7 selects a new transaction
8,8 selects a new group
9,9 Solicit Custom Data ScanLink Call
+ starts/stops the track
/ rotates the piece 90 degrees clockwise
* rotates the piece 180 degrees
-
flips the front and back images
(if the page type is set up to scan front and back images)
Key Function
0,1 -
1,2
selects page types 1 through 12
1 - 9 when the sub-type dialog is displayed, selects page sub-types 1-9
7,7 selects a new transaction
8,8 selects a new group
9,9 Solicit Custom Data ScanLink Call
+ starts/stops the track
/ rotates the piece 90 degrees clockwise
* Toggle popup of “Tab 0”
- Toggle popup of “Tab 1”