140
Falcon+ Operator Manual
OPEX Corporation
Piece Thickness Sensor
Runout Problem
Results when the thickness sensor runout is
greater than the maximum runout defined in the
machine parameters.
Missing Piece at Straight
Through Path
Results when the piece was supposed to go to
the stacker bypass bin but didn't.
Batch Manager has an
Internal Error
Results when there is an internal error within
Batch Manager.
Detected a File Write
Error
Results when the software detects a problem
with writing image or batch files to the specified
directories.
ScanLink Plug-in Failed
Results when there is a failure sending
information to the ScanLink plug-in.
ScanLink Plug-in
Requested a Jam
Results when the ScanLink Plug-in has
requested a jam.
Host to Controller Report
Missing
Results when the controller is expecting piece
information from the host and does not receive it
within the expected time window. This is
frequently caused by pushing the system to its
limits or by something causing the system to get
out of sync.
Jam Caused by Reject
Results whenever a reject other than Jamsorts
occurs. Thus every reject other than Jamsorts is
counted as a jam under this category. The Job
Parameter "Stop Machines for Rejects" must be
set to something other than "No" for rejects to
jam the machine. Otherwise, rejects will be
directed to the reject bin and processing will
continue.
Double Detected
The Multifeed Sensor indicates that two pieces
are being fed together.
MFD Skew Angle
Exceeded Sensor
Blocked
The MFD Skew Angle Exceeded Sensor is
blocked.
Table 5: Reasons for jams (continued)
To Next Page
Loading...
