Optelec ClearReader
+
English Page 14
Turning on the ClearReader
+
To turn on the ClearReader
+
, press the round Power button on
the right-hand side. The start-up process will take approximately
40 seconds. You will hear a series of beeps to indicate that the
ClearReader
+
is starting up followed by the start-up sound. Now
the Power indicator is lit up and the ClearReader
+
is ready to use.
Standby mode
The ClearReader
+
will go into standby mode by pressing, and
holding down the Back button and Forward button for 2 seconds.
The standby sound will be played, the Power indicator will start blinking and the ClearReader
+
will
go into standby mode. To wake up the ClearReader
+
from standby, press the Power button. When
the batteries are fully charged, the standby time of the ClearReader
+
is approximately 40 hours.
After 40 hours the ClearReader
+
will power down. If switching-on the ClearReader
+
from the
standby mode, the start-up process will take approximately 10 seconds.
Turning off the ClearReader
+
Press the Power button to power down the ClearReader
+
completely. The power down sound will
be played and the Power indicator will turn off.
To Next Page
Loading...
Need help?
General
