Optelec ClearReader+ - ClearReader+ does not read the whole line; ClearReader+ does not respond to the Scan button; ClearReader+ does not respond to any button

Optelec ClearReader
+
English Page 39
6. Power and battery use
Checking the battery status
Press the Back and Forward buttons together to check the battery status. The ClearReader
+
will
announce the status in percentage, where 100% means a fully charged battery. If the battery is
low, please charge the battery with the dedicated power supply.
Charging the ClearReader
+
battery
To charge the ClearReader
+
, connect the mains adaptor supplied in the box to the power
connector located at the rear side of the unit. Plug the other side of the adaptor into a power
outlet.
Charging the ClearReader
+
takes approximately 3 hours. A fully charged ClearReader
+
can
operate for approximately 5 hours. Please note that, for safety reasons, only the adaptor
supplied by Optelec should be used to charge the ClearReader
+
.
Extending the battery life
To ensure the battery pack maintains maximum capacity, disconnect the ClearReader
+
from the
power source at least once a month and operate it on battery power until the battery pack is
empty.