Optelec ClearReader+ - Overview

Optelec ClearReader
+
English Page 21
Philips screwdriver to remove the screw which closes the cover. This screw is located in the
middle of the cover at the bottom side of the ClearReader
+
. Connect the monitor to the
ClearReader
+
by using a VGA cable. Adjacent to the VGA connector, there are two USB ports.
Connect the USB cable of the ClearReader
+
Magnification Feature Pack to one of the two USB
ports on the rear side or to the USB port on the right side of the unit.
When the Magnification Feature Pack is connected to the ClearReader
+
, switch on the
ClearReader
+
and take a snapshot of a document as described in this manual.
Magnification views
With the ClearReader
+
Magnification Feature Pack, you can view captured documents in four
different Views: Page view, Column view, Line view and as a full page Overview. To switch
between the different views, press the Mode button on the Magnification Feature Pack.
Page View
The Page view shows a photograph of the document in its original layout, including the pictures.
Column View
In the Column view the text is reformatted and displayed in a column to fit the width of the screen
regardless of the text size. Pictures are not shown in this view.
Line View
In Line view the text is reformatted and displayed in one continuous line, and the highlighted word
is always displayed at the centre of the screen. Pictures are not shown in this view.