Optex iVision+ User Manual

- 11 -
7. Other Settings
7-1. Talk Switching Mode Setting
SYSTEM SETUP
1 DATE & TIME
2 SYSTEM CONFIGURATION
3 DEVICES IN NETWORK
4 PC CONNECTION
OK BACK
SYSTEM CONFIGURATION
1 NUMBER OF CAPTURING IMAGE
2 TALK SWITCHING SETUP
OK BACK
TALK SWITCHING SETUP
PRESS UP OR DOWN KEY TO SET UP
2 AUTO(LOW NOISE)
3 AUTO(MIDDLE NOISE)
4 AUTO(HIGH NOISE)
OK BACK
1 MANUAL
(1) Enter SYSTEM SETUP menu by pressing LEFT function
key for more than 3 seconds.
By default, Talk Switching Setup between a Door Camera Unit
and a Handheld Monitor Unit is set to AUTO(MIDDLE NOISE).
This means that a conversation switches automatically from
a listener to a speaker on either side of the intercom when
an unit is picking up a voice or any relevant sound.
If you wish to change the setting, please take following
procedures.
(3)
Select “2 TALK SWITCHING SETUP” by using UP and
DOWN keys and press LEFT function key to confirm “OK”
(4)
In TALK SWITCHING SETUP screen, select a mode from 1 to
4 by using UP and DOWN keys and press LEFT function
key to confirm “OK”.
1 MANUAL
2 AUTO(LOW NOISE)
3 AUTO(MIDDLE NOISE)
4 AUTO(HIGH NOISE)
This is a “Push to talk” mode. Door Camera Unit only receives a voice or
a sound from a Handheld Monitor Unit when LEFT function key is being
pressed. Use this mode to avoid unwanted sound from the house to be
heard from a Door Camera Unit.
Listener and speaker side switches automatically in this mode. Use this
in a very quiet and low noise environment to enhance conversational
responses.
Listener and speaker side switches automatically in this mode.
This is a factory default setting.
Listener and speaker side switches automatically in this mode. Use this
with a noisy environment to enhance conversational responses.
Press LEFT function key
to speak to a Door Camera Unit
(Effective in all settings)
(2) Select “2 SYSTEM CONFIGURATION” by using UP and
DOWN keys and press LEFT function key to confirm “OK”
7-2. Sensor Alert Enabling/Disabling Setting
While Door Camera Unit(IVP-DU) is powered by an external power source and OPTEX
Wireless2000 TD-20U is connected to iVISION+ system through Gateway Chime Unit,
calls can be triggered by motion detectors, capturing images from the IVP-DU.
In order to change this setting, enter ENABLE/DISABLE SENSOR ALERT menu by
pressing RIGHT function key for more than 3 seconds. Confirm by LEFT fucntion key
to switch setting or cancel by RIGHT function key.
Sensor Alert Enabled: TD-20U triggers a call to iVISION+ system.
Sensor Alert Disabled: TD-20U does not trigger a call to iVISION+ system.
3 DOOR OPEN DURATION SETUP

Optex iVision+ Specifications

General

Brand	Optex
Model	iVision+
Category	Intercom System
Language	English