Optex VX-402 - Pole Mounting; Electric Box Mounting; Wiring and Connections

3-3.Pole Mount
An installation pole with an outside diameter of 43mm(1.66") must be used.
(Standard
U.S.1'/,"pipe
has
an
outside
diameter
of
1.66".)
Wiring
Sponge
Pad
Agoras
Sher lEC 1
i
Approx. |
tasom |
i
For outdoor wiring, bury piping as Peel off one of the two Fix bracket onto mounting plate with
deep as possible. Some sites will sealings along the supplied screws (M4x6,4pcs).
require metal coated cables for dotted line. Place the bracket around the pole
underground wiring work. and tighten firmly with pole locking
Avoid aerial wiring screws.
3-4.Electric Box Mount 3-5.Conduit Installation
wet
Knockout
For connections to single gang Conduit can be installed directly into the bottom of the unit by
electric boxes, follow instructions removing the knockout on the bottom on the cover.
for wall mounting.
| 4. WIRING
VX-402 VX-402REC
POWER INPUT:9.5 - 18VDC POWER INPUT:9.5 - 18VDC.
ALARM OUTPUT:[NC/NO] SELECTABLE ALARM OUTPUT. [NC/NO] SELECTABLE
| SPARE SPARE ‘VOICE OUTPUT
AUX INPUT:[NC] VOICE CONTROL INPUT
AUX INPUT:[NC]
TAMPER:(NC] TAMPERING]
= JUMPER JUMPER
O CAR3e0'
=A "|
Power wires should not exceed the following lengths
IMPORTANT
VX-402
VX-402REC
*Do
not
remove
jumper
while
WIRE
GAUGE
12V
14
12V
tav
slave
is
not
connected.
AWG
22(0.33mm’}
|
200m(670!}
|
400m(1330ft)
|
110m(370Ft)
|
230m(77~oR)
*Use
AUX
INPUT
terminal
only
AWG
20(0.52mmn4)
|
340m(11300t)
|
640m(21301)
|
180m(600rt)
|
360m412001)
when
slave
is
used.
AWG
18(0.83mm*)
|
510rm(17008t)
|
1020m(3400f)]
230mg7ott)
|
570m(1
900)
5.