OPTICLIMATE SPLIT PRO3 Series - Timer Programming (Day;Night)

14
7) Timer setting (DAY / NIGHT program)
By default, we recommend to use the timer, automatic light sensor mode
So only set if you want it to work without light cell.
This function can be used for the DAY / NIGHT program. This program restarts, every day no matter
what day it is. The timer is set, when the display shows the clock symbol.
Press 【T】 key for 2 seconds, when "---", ON is visible, the user can set the timer
To change setting. Pressing ▲ or ▼ on the hours the ON time can be set by pressing 【T】again the
minutes can be set. The ON time is the time that the unit is cool.
When 【T】is pressed again the OFF time can be set. The OFF time is time the unit is heating /
dehumidification.
The display will show "-: -" If there is no timer set, or else the time that is already set.
Example:
The unit must cool down between 8:00 and 20:00.
The ON time should be set to at 8:00 AM
OFF time must be set to 8:00 PM
1:00 AM = 1:00
1:00 PM = 13:00
2:00 AM = 2:00
2:00 PM = 14:00
3:00 AM = 3:00
3:00 PM =15:00
4:00 AM = 4:00
4:00 PM =16:00
5:00 AM = 5:00
5:00 PM =17:00
6:00 AM = 6:00
6:00 PM = 18:00
7:00 AM = 7:00
7:00 PM = 19:00
8:00 AM = 8:00
8:00 PM = 20:00
9:00 AM = 9:00
9:00 PM = 21:00
10:00 AM = 10:00
10:00 PM = 22:00
11:00 AM = 11:00
11:00 PM = 23:00
12:00 PM = 12:00
12:00 PM = 24:00
To delete the time during the timer setting (turning off of the timer)
Press 【R】 key, and the time is erased. The display will show "-: -" display.
EXIT: Press 【T】key 3 times to exit or wait 10s to close automatically.
The settings must run synchronously with of the current time and timer settings with the times on the
switchboard. All clocks must be synchronized when the timer function is used.