4
If you want to use a different PIN code or you are only allowed to enter a random
PIN code on your OPN2002, then you will have to enter this PIN code using direct
input labels. These labels can be found in the universal menu book (or below). After
entering the PIN code read the END label to send the PIN code to the remote
device.
When executed correctly your OPN2002 should now be connected as keyboard and
you should be allowed to scan and transmit barcodes as keyboard data. If the
remote device does establish the pair, but doesn't automatically connect, you might
have to manually connect afterwards by pressing the trigger key for 5 seconds.
To manually end a connection you can press the small clear key for 5 seconds to
disconnect your OPN2002.
If you've lost your connection, then the OPN2002 will try to reconnect automatically
once after about 1 minute, but if that fails you can reconnect manually by pressing
the trigger key for 5 seconds. The trigger key allows you to reconnect without having
to enter the PIN code again as long as the remote device doesn't lose the pairing
information and the OPN2002 wasn't reset to default or the remote Bluetooth
address was changed.
If the pair was ever lost or you want to connect to another remote device you will
have use the clear key again to make your OPN2002 connectable and allow the
remote device to connect and pair with your terminal.
To Next Page
Loading...
Need help?
General
