6
Connect as master
When you want your OPN2002 to connect with a remote device you can either read
the created Bluetooth address labels or you can choose to press the trigger key for
5 seconds (until the blue LED starts blinking).
Even though authentication is not recommended when using VCP it is possible that
you are requested to enter a PIN code on your PC. By default the PIN code of the
OPN2002 equals the last 4 digits of the Bluetooth address.
When executed correctly your OPN2002 should now be connected as Virtual COM
port on your remote device and you should be allowed to scan and transmit
barcodes as serial data.
If you've lost your connection, then the OPN2002 will try to reconnect for about 1
minute, but if that fails you can also reconnect manually by pressing the trigger key
for 5 seconds.
To manually end your connection you can press the small clear key for 5 seconds to
disconnect your OPN2002.
Connect in slave mode
When you want the remote device to connect with your OPN2002, then it is not
necessary to configure the remote Bluetooth address, but you will have to make
your OPN2002 discoverable and connectable to allow the remote device to find and
connect to your OPN2002.
To make your OPN2002 discoverable and connectable for 60 seconds keep the
small clear key pressed for 5 seconds till the blue LED starts blinking. After that you
should let your remote device discover all Bluetooth devices in range to find your
OPN2002.
After you've successfully discovered your OPN2002 you can try to let your remote
device connect with your OPN2002.
If successful, the OPN2002 should now be connected as Virtual COM port on your
remoted device and you should be allowed to scan and transmit barcodes as serial
data.
If you've lost your connection, then the OPN2002 will become connectable again for
about 60 seconds, but if that fails you can reconnect manually by pressing the small
clear key again for 5 seconds.
To manually end your connection you should press the small clear key for 5
seconds to disconnect your OPN2002.
To Next Page
Loading...
Need help?
General
