Attachments: Never add any attachments
and/or equipment without the manufacturer
consent; as such additions may result in the risk of fire, electric shock, or other personal injury.
Locating: Slots and openings in the c
abinet are provided for ventilation to protect it from
overheating. Do not block these openings or allow them to be blocked by placing the STB on
a bed, sofa, or other similar surface, nor should it be placed over a radiator or heat register.
Power-Cord Protection: Place the power-
supply cord out of the way, where it will not be
walked on. Please take special attentions to cords at plugs, convenience
point where they exit from the unit.
Object and Liquid Entry: Never put objects of
any kind into this STB through openings, as
they may touch dangerous voltage points or short-
out parts that could result in a fire or electric
shock. Never spill any liquid on the STB.
Note: Moisture may be formed on the lens In the following conditions:
• when the unit is suddenly moved from a cold environment or an air-
to a warm place.
• immediately after a heater has been turned on.
• in a steamy or very humid room.
If the moisture forms inside the unit, it may not operate properly. To corre
on the power and wait about two hours for the moisture to evaporate.
When the unit parts need to be replaced, user should make sure the
service technician use the replacement parts specified by the manufacturer o
r having the
same characteristics as the original part. Unauthorized replacement may put the unit In the
risk of fire, electric shock or other hazards.
After all the maintenances and repairs are done, user is required to request
e technician to conduct the overall safety check to ensure the machine is In the
To Next Page
Loading...
Need help?
General
