Optima Scale OPF-P - Page 12

10
Selection of PLU Function
• There are two modes for PLU setting: ON & OFF
• In User Setting Mode, select “PLU?”
• The ashing number on the second line shows the present setting value
• Press [ZERO] or [TARE] to change the value
• Press [M+] to conrm the revised value or press [UNIT WEIGHT] to
cancel the revision and exit the function setting
Selection of Communication Address
• You can set an address for your scale to better communicate with its PC
or printer (especially if multiples scales are in use). Doing so will help
the scale know when a command from the PC is meant for it versus
another scale
• The range is 1-25 with default set at 1
• In User Setting Mode, select “SCALE?”
• The ashing number on the second line shows the present setting value
• Press [ZERO] or [TARE] to change the value
• Press [M+] to conrm the revised value or press [UNIT WEIGHT] to
cancel the revision and exit the function setting
Selection of BPS (Bits Per Second) / Baudrate
• When the BPS of the scale and the communication equipment is not the
same the communication may not function properly.
• There are 3 selections: 2400, 4800 & 9600 with 9600 being default
• In User Setting Mode, select “BAUD?”
• The ashing number on the second line shows the present setting value
• Press [ZERO] or [TARE] to change the value
• Press [M+] to conrm the revised value or press [UNIT WEIGHT] to
cancel the revision and exit the function setting
Selection of Transmission
• This function is for selecting a communication mode that is active when
the scale is connected to a printer/computer and the relative
equipment. There are three modes selectable
• There are 3 selections: Continuous Transmission, Stable Transmission,
Response Transmission
• In User Setting Mode, select “SENT?”
• The ashing number on the second line shows the present setting value
• Press [ZERO] or [TARE] to change the value
• Press [M+] to conrm the revised value or press [UNIT WEIGHT] to
cancel the revision and exit the function setting