4
OPERATING INSTRUCTIONS
Power On
• Turn on the power by ipping the switch located on the underside of the
scale to the right. Once on, the scale will show the voltage and au-
to-check by counting down from 0-9 sequentially
Zeroing
• If the screen reads any number other than 0 before weighing, press the
ZERO key to set to 0 (be sure points to ZERO)
Note: The zero range is 4% max capacity
Unit Selection
• To switch between measuring units (kg, g, lb, oz) press the [UNITS/
PRINT] key
Tare Function
• Put a container you wish to use on the pan, then press the [TARE] key
and the display will show pointing to TARE and reset back to 0
• Add your sample to the container to weigh without the weight of the
container
• To exit Tare mode simply press [ZERO] key
Note: If you remove your container the scale will show the minus weight of
the container
Sample Setting (Setting the sample weight)
There are two ways of setting a sample weight
Number Setting: for when you don’t know the weight of the object
• Press [CE] for canceling the previous unit weight and sample setting
• Place objects on the scale
• On the keypad enter how many objects you placed on the scale
• Then press [SAMPLE] key
• The scale will calculate and then show the number of your sample on
the third line
• You can now add objects to the scale and it will count them
Unit Weight Setting: for when the weight of the unit is already known
• Press [CE] for canceling the previous unit weight and sample setting
• On the keypad enter the weight of your object then press the [UNIT
WEIGHT] key. Add objects for scale to count
To Next Page
Loading...
