5
Accumulation
• Accumulation mode keeps track and adds your totals together for you
• Press [M+] to accumulate the current quantity to the total quantity
• Then press [UNIT WEIGHT] key to go back to the normal counting mode
• From there you can use the scale again and when you want to add your
total to the accumulation press [M+] (up to 99 totals can be accumulated)
• Press [CE] to clear the times of counts
Accumulation Checking
• In weighing mode press [TOTAL] key to enter the accumulation checking
mode and view the accumulation total
• Press [UNIT WEIGHT] key to go back to the normal counting mode
• Press [CE] to clear the times of counts
Quantity Check Alarm
• This function allows you to set an alarm when there are too many or too
few objects on the scale. For example you can set an alarm to go off
when you have under 10 units on the scale or an alarm when you have
over 100 units, or both at the same time
• Press [QUANTITY CHECK] key to enter the quantity check setting mode
• Turn this function On or Off by pressing the [ZERO] key
• To set a Low alarm press the [M+] Key and enter the amount you want
to set on the keypad (entering 0 disables low alarm)
• To set a High alarm press the [M+] Key again and enter the amount you
want to set on the keypad (entering 0 disables high alarm)
• Press [M+] key again to set the alarm and exit quantity check setting
mode
To Next Page
Loading...
