LED states
On Screen Messages
Fan failed:
The projector will switch o automatically.
Over temperature:
The projector will switch o automatically.
Replacing the lamp:
Lamp is approaching the end of its rated life.
Replacement suggested.
Remote Control
If the remote control does not work
Check the operating angle of the remote control is within
±15° both horizontally and vertically of on of the IR
receivers on the projector.
Make sure there are no any obstructions between the
remote control and the projector. Move to within 7 m (23 ft)
of the projector.
Make sure batteries are inserted correctly.
Replace batteries if they are exhausted.
Warning:
Only use genuine
lamps.
To Next Page
Loading...
