Optoma ML1050ST+ - Specifications; Optical Specifications

58
English
Specication
Optical Description
Maximum resolution WXGA (1280x800)
Lighting source RGB LED (LED life=20,000hrs)
Lens Manual focus
Image size (diagonal) 50" ~ 100", optimize at 60”
Projection distance 0.86m~1.72mm, optimize at 1.033m
Electrical Description
Inputs - Universal VGA in x1 (need to use special cable),
- HDMI/MHL in x1,
- USB-A x 1, Micro SD x 1
Outputs Headphone out x1
Color reproduction 16.7 Million color
Scan rate - Horizontal scan rate: 15.375 ~ 91.146 KHz
- Vertical scan rate: 24 ~ 120 Hz (120Hz for 3D featured)
Built-in speaker Yes, 1.5W (Amplifier)
Power requirement AC Adapter, Input 100 - 240V ±10%, AC 50/60Hz, Output 19V DC (to
projector), Standby Mode < = 0.5W
Input current AC in 1.7A (DC in 3,42A)
Multimedia Description
FW based Linux similar OS
USB-A portion - For firmware upgrade (USB 1.1 support)
- Supports Host mode for USB storage disk (USB 2.0 support
up to 64GB).
- Supports WiFi dongle
- Supports 5V/0.5A power for 3C device
Micro-SD slot - Supports Micro SD & SDHC card (up to 64GB)
- SDXC & UHS-I card types are not supported
Mechanical Description
Installation orientation Desktop/Front, Desktop/Rear
Dimensions 112.5 x 105 x 40.5mm (w/o lens ring and rubber foot)
Weight 0.46 kg
Environmental
conditions
Operating: 5 ~ 40°C in Bright mode and ECO mode, 10% to 85%
humidity (non-condensing)
Note: All specications are subject to change without notice.