English
37
USING THE PROJECTOR
Background Color
Use this function to display a blue, red, green, gray color, or none when no signal is available.
HDMI 1 EQ
Set the HDMI port EQ value for HDMI1.
HDMI 2 EQ
Set the HDMI port EQ value for HDMI2/MHL.
Note:
HDMI EQ analyses the signal data and eliminates distortion due to signal loss when using long HDMI
cables. The HDMI receiver also includes a timing adjustment circuit that removes timing jitter, restoring
the HDMI signal to optimal transmission levels.
3840x2160@60Hz suggests using the HDMI cable under 5 meters.
3840x2160@30Hz/25Hz/24Hz suggests using the HDMI cable under 15 meters.
Setup reset OSD menu
Reset OSD
Return the factory default settings for OSD menu settings.
Reset to Default
Return the factory default settings for all settings.
Network menu
Network LAN menu
Network Status
Display the network connection status (read-only).
MAC Address
Display the MAC address (read-only).
DHCP
Use this option to enable or disable the DHCP function.
On: Projector will obtain an IP address automatically from your network.
Off: To assign IP, subnet mask, gateway, and DNS conguration manually.
Note: Exiting OSD will automatically apply the entered values.
IP Address
Display the IP address.
Subnet Mask
Display subnet mask number.
Gateway
Display the default gateway of the network connected to the projector.
DNS
Display the DNS number.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
