Name: Optoma UHD60
Brand: Optoma
Rating: 4 (1 reviews)

To Next Page

To Previous Page

English

USING THE PROJECTOR

RS232 by Telnet Function

There is alternative RS232 command control way, in projector so called “RS232 by TELNET” for LAN / RJ45

interface.

Quick Start-Guide for “RS232 by Telnet”

 Check and get the IP address on OSD of the projector.

 Make sure that the PC / laptop can access the web-page of the projector.

 Make sure that “Windows Firewall” setting is set disabled in case of “TELNET” function ltering out by

PC / laptop.

1. Select Start > All Programs.> Accessories > Command Prompt.

2. Input the command format as follows:

± telnet ttt.xxx.yyy.zzz 23 (“Enter” key pressed)

± (ttt.xxx.yyy.zzz: IP-Address of the projector)

3. If Telnet-Connection ready, and user can have RS232 command input, then “Enter” key pressed, the

RS232 command will be workable.

Specication for “RS232 by TELNET”:

1. Telnet: TCP.

2. Telnet port: 23 (for more detail, kindly please get contact with the service agent or team).

3. Telnet utility: Windows “TELNET.exe” (console mode).

4. Disconnection for RS232-by-Telnet control normally: Close

5. Windows Telnet utility directly after TELNET connection ready.

± Limitation 1 for Telnet-Control: there is less than 50 bytes for successive network payload for

Telnet-Control application.

± Limitation 2 for Telnet-Control: there is less than 26 bytes for one complete RS232 command for

Telnet-Control.

± Limitation 3 for Telnet-Control: Minimum delay for next RS232 command must be more than 200 (ms).

Questions and Answers:

Need help?

Do you have a question about the Optoma UHD60 and is the answer not in the manual?

Optoma UHD60 Specifications

General