Name: Optoma UHD60
Brand: Optoma
Rating: 4 (1 reviews)

To Next Page

To Previous Page

English

MAINTENANCE

Replacing the lamp (continued)

Procedure:

1. Switch off the power to the projector by pressing the “ ” button on the projector keypad or the “ ”

button on the remote control.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Push down rmly on the middle of the top cover to unlock the latch. 1

5. Open the top cover. 2

6. Loosen the 2 screws on the lamp cover. 3

7. Remove the lamp cover. 4

8. Loosen the screw on the lamp module. 5

9. Lift up the lamp handle. 6

10. Remove the lamp cord. 7

11. Remove the lamp module carefully. 8

12. To replace the lamp module, reverse the previous steps.

13. Turn on the projector and reset the lamp timer.

14. Lamp Reset: (i) Press "Menu"  (ii) Select "Setup"  (iii) Select "Lamp Settings"



(iv) Select "Lamp

Reset"



(v) Select "Yes".

Questions and Answers:

Need help?

Do you have a question about the Optoma UHD60 and is the answer not in the manual?

Optoma UHD60 Specifications

General