Install Windows Server 2012 or 2012 R2 Using PXE Network Boot
Note - The boot device menu that appears in your installation might differ depending on the
type of disk controller installed in your server.
5.
In the Please Select Boot Device menu, select the network port that is configured
to communicate with your PXE network install server.
The network bootloader loads and a boot prompt appears. After a few seconds the installation
kernel will begin to load.
6.
To complete the installation, refer to Step 5 of “Install Windows Server 2012 or
2012 R2 Manually Using Local or Remote Media” on page 39.
64 Oracle Server X5-2 Installation Guide for Windows Server Operating Systems • April 2016
To Next Page
Loading...
