2-14 Installation
3) In the Dante network, route audio to and from the 5750.
A Dante device has a number of channels associated with it. These are either transmit (TX) or receive (RX)
channels. Your OPTIMOD provides two Dante stereo transmit channels and two stereo receive channels. Receive
channels and devices are listed down the left side of the grid in the Dante Controller software. Transmit channels
and devices are listed along the top of the grid. Transmit channels are advertised on the network. A receiver
uses this advertisement to establish a subscription to the channel. A transmit channel can be sent to multiple
receivers using unicast or multicast. Receive channels are connected to transmit channels via a subscription.
Each receive channel will receive audio over the network from at most one transmit channel. The 5750’s Dante
inputs are:
• Channel 1 = DANTE 1 LEFT INPUT
• Channel 2 = DANTE 1 RIGHT INPUT
• Channel 3 = DANTE 2 LEFT INPUT
• Channel 4 = DANTE 2 RIGHT INPUT
The 5750’s Dante outputs are:
• Channel 1 = DANTE 1 LEFT OUTPUT
• Channel 2 = DANTE 1 RIGHT OUTPUT
• Channel 3 = DANTE 2 LEFT OUTPUT
To Next Page
Loading...
Need help?
General
