Air filter:
(KAWASAKI)
Remove the air filter cover. Unscrew the two screws (A, Fig 25). Unscrew the collar (B, Fig 26), blow
the cartridge with low air pressure from the inside to the outside opposite to the normal air flow.
Change the cartridge if it is too dusty after some cleaning. Clean the foam with water and soap, dry it
and oil with engine oil. Press it to remove the oil in excess without squeezing it.
IMPORTANT
Do not blow at high pressure, and maintain a safe distance between the air nozzle and the
cartridge to avoid damage on it.
(Briggs & Stratton)
Remove the air filter (1, Figure 29) by the two clips "A", remove the cartridge after unscrewing the
wing nut (1, Figure 30). Clean the foam with water and soap, let it dry and oil it with motor oil. Press it
to eliminate oil in excess. Blow the cartridge with low air pressure from the inside to the outside
opposite to the normal air flow. Change the cartridge if it is too dusty or after some cleaning.
IMPORTANT
Do not blow at high pressure, and maintain a safe distance between the air nozzle and the
cartrige to avoid damage on it.
Check when reinstall the cartridge that dusty air is obliged to go inside engine by the cartridge.
To Next Page
Loading...
