OREC RABBIT RM882 - Page 22

OREC RM881 - © SAT 2021-05-06
22
Engine:
(KAWASAKI)
Refer according to engine manual delivered with the
machine.
Oil level: check that the oil level and engine is not hot. Un-
screw the gauge (1, Fig 31). The oil must be between the
two marks on the tank.
Drain the oil by the plug after the first 8 hours and after
every 100 hours of use or every year whichever comes first
(Fig 28).
Use oil: SAE10W30 or APL SL class
Oil quantity: 1.7L(RM882/RM952) or 2.1L(RM982F).
(Briggs&Stratton)
Refer to engine manual deliver with the machine.
Oil level: check by the gauge “A” (Figure 32). With the engine
stopped since 5 minutes on a flat level surface, unscrew the
gauge A, wipe the bottom and put it back on his location.
Check the level is between upper and lower. Add engine oil if
necessary. Drain oil by the plug C.
Fuel filter
(KAWASAKI)
Check through the filter(2, Fig 31) if there is dirt or water.
Clean or change the filter if necessary.
(Briggs&Stratton)
- Check for water and dust in the fuel cartridge filter cock (Figure 9). Clean if needed the filter inside
the fuel cock.
- Check for water and dust in the fuel cartridge filter (Figure 32). Replace the filter if it is dirty.
Figure 29
Figure 30
Figure 31
Figure 32
2
1
A
B
１