EN
10
To force a manual search for Atomic Clock signals, press
and hold UP for 2 seconds. If no signal is found, check
the batteries.
TURN ATOMIC CLOCK ON/OFF
Perform this step if you cannot receive Atomic Clock
signals. Press and hold ZONE (located in the battery
compartment) for 2 seconds. Then, manually set the
clock following the “Set Clock” instructions (below).
SET CLOCK
You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1. Open the battery compartment.
2. Press ZONE repeatedly to display the desired Time
Zone: (P) Pacific, (M) Mountain, (C) Central, or
(E) Eastern.
The signal icon indicates that the Atomic Clock
feature is ON. No icon means that it is OFF
3. Close the battery compartment.
4. Press and hold MODE for 2 seconds. The Clock
Area will blink.
5. Select the hour, minute, year, month, day and
language. Press UP or DOWN to change the
setting. Press MODE to confirm.
The language options are (E) English,
(F) French, and (S) Spanish.
SWITCH CLOCK DISPLAY
Press MODE to toggle between Clock with Seconds,
Clock with Weekday, and Calendar display.
ALARM
This product is equipped with a 2-minute crescendo alarm
and 8-minute snooze.
VIEW ALARM SETTINGS
Press ((.)). The Alarm Time and On/Off status will show
in the Clock Area.
NOTE
RMR606HGPA_R5 9/3/04, 4:16 PM10
To Next Page
Loading...
Need help?
General
