To Next PageTo Next Page
Need help?Do you have a question about the Oriental motor AXH Series and is the answer not in the manual?
General| Brand | Oriental motor |
|---|---|
| Model | AXH Series |
| Category | Engine |
| Language | English |
Details regarding compliance with Low Voltage and EMC Directives.
Lists applicable standards and specifies environmental conditions for installation.
Covers general handling, environmental hazards, personnel, and protection function safety.
Safety measures for product installation and electrical connections.
Safety for operation, repair, general handling, and hot surfaces.
Safety for installation, ventilation, covers, and emergency operational procedures.
Guidelines for correct product disposal according to laws and regulations.
Techniques for suppressing and preventing electrical noise propagation.
Procedure for checking supplied items and identifying components.
Table detailing combinations of gearheads, motors, and drivers.
Identification and description of driver components and their functions.
Specifies environmental and location criteria for product installation.
Details on how to install the motor and gearhead.
Describes mounting procedures for round shaft, combination, and geared types.
Guidance on connecting loads to motor or gearhead shafts.
Instructions for installing the driver unit.
Measures for installing and wiring to comply with EMC directives.
Techniques for suppressing and preventing electrical noise propagation.
Illustrates EMC compliant installation and provides static electricity precautions.
Procedure for connecting the motor cable to the driver.
Instructions for connecting the power supply to the driver.
Details on connecting input and output signal cables to the driver.
Illustrates typical input and output signal connection configurations.
Explains the function and behavior of various input signals.
Details on specific input signals for motor control.
Procedure for alarm reset and description of speed output signal.
Visual representation of signal timing and motor operation patterns.
Explains driver protection functions indicated by LED flashes and alarm output.
Procedure for setting motor speed using the internal potentiometer.
Procedure for setting motor speed using an external potentiometer.
Procedure for setting motor speed using an external DC voltage source.
Key items to check after motor operation for potential issues.
Troubleshooting steps for when the motor does not start or turn.
Troubleshooting steps for when the motor stops during operation.
Diagnosing and correcting issues with motor rotation direction.
Troubleshooting causes for unstable operation and excessive vibration.
Troubleshooting when the motor fails to stop instantaneously.
