Oriental motor US2 Series

Other manuals for Oriental motor US2 Series

Quick Start Guide2 pages

Questions and Answers

S
Stacy CampbellAug 13, 2025
What to do if Oriental motor Controller motor does not rotate?
- L
  Laura MartinezAug 13, 2025
  If the Oriental motor Controller motor does not rotate, there are several possible causes. First, check the motor cable connection. Second, ensure the operation switch on the speed controller is set to the "RUN" position, not "STAND-BY". If using external signals, verify that the "external operation signal input" parameter is set correctly to " ." Also, make sure that either the FWD or REV input is ON, and that the applied voltage is within the specified range. Finally, confirm that you are using the correct combination of motor and speed controller.
A
Allison JohnsonAug 17, 2025
Why does my Oriental motor US2 Controller rotate in the opposite direction?
- C
  Charles FreemanAug 17, 2025
  The Oriental motor Controller might rotate in the opposite direction because the rotation direction switch is set to the wrong side. Another reason could be the usage of a gearhead that rotates in the opposite direction. Finally, if using external signals, the FWD and REV inputs might be connected incorrectly or improperly. Check these connections to resolve the issue.
K
Kristen RobinsonAug 20, 2025
How to fix Oriental motor Controller when speed cannot change?
- G
  groseAug 21, 2025
  If the speed of the Oriental motor Controller cannot be changed, it might be due to a limited setting range for the rotation speed. Check the settings for the "speed upper limit" and "speed lower limit" parameters.
T
Thomas WhiteAug 25, 2025
Why I cannot increase the rotation speed on my Oriental motor Controller?
- P
  parkerronaldAug 25, 2025
  If the rotation speed of your Oriental motor Controller cannot be increased, it is likely that the speed upper limit is set. To resolve this, increase the speed upper limit.
J
Joshua DelgadoAug 28, 2025
What to do if rotation speed cannot be decreased on Oriental motor Controller?
- C
  Courtney SchneiderAug 28, 2025
  If the rotation speed of your Oriental motor Controller cannot be decreased, it is likely that the speed lower limit is set. To resolve this, decrease the speed lower limit.
J
Jeffery RoblesSep 1, 2025
Why is the Oriental motor US2 Controller operation unstable?
- A
  Alexander GonzalezSep 1, 2025
  Unstable operation and excessive vibration in your Oriental motor Controller could be due to electrical noise affecting the product. Also, ensure you are using the correct combination of motor and speed controller.
B
bsavageSep 5, 2025
Why Oriental motor US2 motor doesn't start instantaneously?
- N
  Natalie ClarkSep 5, 2025
  If your Oriental motor Controller motor doesn't start instantaneously, it could be because the acceleration time is set too long. Try adjusting the acceleration time. Another possible cause is that the load inertia is too large, so revise the load inertia.
D
Dalton AverySep 9, 2025
What to do if Oriental motor US2 Controller display is blank?
- A
  agalvanSep 9, 2025
  If nothing is indicated on the display of your Oriental motor Controller, even when the power is supplied, the power supply might not be connected properly. Check the connection of the AC power supply.