Orion OLMU-5520 - Cable Connection Guide; Single Connection Setup

- 18 - - 19 -
3.1. Connection of Single
•
Monitor and PC should be connected; a Com Port in a PC and RS-232C IN port in a monitor is connected with supplied
RS-232C cable.
•
If you do not have Com Port, you need to use an USB converter for RS-232C. Depending on manufacturers or models,
converters may cause malfunction.
3. How to Connect Cables
•
Do not connect/disconnect cables while monitor or other external equipments are turned on.
•
First turn off the power all the attached equipment and make connections.
•
Make sure the power cord is inserted properly into the power inlet to prevent unexpected pullout of the cord.
LAN IR RS232C IN RS232C OUT DP IN HDMI 1-IN HDMI 2-IN DVI IN DVI OUT PC INAC IN
Control PC
DVD player
HDMICable ((Max. Length : 5m)
DP Cable ((Max. Length : 5m)
HDMICable ((Max. Length : 5m)
DVI connection ((Max. Length : 5m)
HUB or Router
LAN Cable (Direct cable)
LAN Cable
(Direct cable)
LAN Cable (Cross cable)
RS-232 (Max. Length : 15mm)
PC Connection (Maximum 5m)