Orion OLMU-5520 - MSCS Timer and Tracking; Timer Control for Power; Tracking Control for Alignment

- 48 - - 49 -
4.10.3. Timer Control
•
Users can decide the time of turning on or off MLCD set by timer control.
•
To
use this function, click Menu

Control

Timer Control or use 'Ctrl +M' keys from the keyboard.
•
How to set the time of power on or off.
1) Select Hour and Minutes of turn on or off
2) After setting Power On/Off time, click
“
Add
”
button to add it to Power On/Off List Box.
You can save up to 10 settings for Power On/Off. Also, you can delete the saved settings in the List Box one by one
with
“
Remove
”
button. If you delete all the settings, click
“
Remove All
”
button.
3) Se
lect once for one time use and Daily for daily use, then click 'Start'
4) Power on or off signal will be transmitted to MLCD at the time of user set.
•
Time Dialog must be activated to use Timer function
Timer Control Dialog
•
Go to "Control" in menu bar

Tr
acking Control or press "Ctrl+T" using keyboard to run
"Tr
acking" window.
•
Press "Auto Tr
acking" button in order to run auto tracking.
•
In case alignment doesn't work through "Auto Tr
acking" command, user can tune finely
through "Manual".
•
Manual Tracking enables users to set H Position, V Position, Clock and ClockPhsae.
•
Select panel ID which you want to adjust alignment.
•
Detail adjustment steps are as follows.
1) Tu
ne "ClockPhase" until the vertical lines are clearly adjusted..
2) Tu
ne "V Position" to adjust vertical alignment. "H Position" for horizontal alignment.
3) A
djust "Clock" if alignment is still wrong.
If you adjust "Clock", repeat step 1) and 2) to fit alignment.
Adjustable range is as follows
-The range of
"H Position"
you can adjust is 0 to 100
-The range of
"V Position"
you can adjust is 0 to 100
-The range of
"Clock"
you can adjust is 0 to 100
-The range of
"ClockPhase"
you can adjust is 0 to 63
•
Click "EXIT" button or press "Ctrl+X" using keyboard to close "Tracking" window.
※ When "Tracking" windows is on display, users cannot display "Picture Control" window.
※ Even when "Tracking" window is on display, selecting panel ID is available by clicking right button of
mouse.
4.10.4. Tracking Control
•
Alignment adjustment is available when input source is PC.
Tracking Manual Window