Orion OLMU-5520 - Control Cable Setup; RS-232 C Control Cable; Ethernet Control Cable

- 24 - - 25 -
3.6. Connection of Control Cable
•
Control signal transmission can be connected by 3 different methods.(RS-232C or Ethernet or IR)
•
RS-232C and Ethernet connection cannot be used simultaneously.
•
All control signals are output to the RS-232OUT after conversion to RS-232C signal.
3.6.1. Connection of RS-232C Cable
•
Maximum use of RS-232C with Daisy Chain connection is 30 sets or less, if you need additional connection, use
RS-232C distributor.
3.6.2. Connection of Ethernet Cable
•
In case of Ethernet connection, the control PC should be connected to one of monitor sets with Ethernet cable.For
the connection between the monitor sets, they should be connected with RS-232C cables.
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
RS-232C control PC
RS-232C
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
LAN IR RS232C IN RS232C OUT
Ethernet control PC
HUB or Router
(Wireless & Cable)
LAN Cable
(Direct Cable)
LAN Cable
(Direct Cable)
LAN Cable (Cross Cable)