100 to 240 V
AC
, 50/60 Hz, ±10 %
Maximum power draw:
TCXO/OCXO oscillator installed: 40 W normal (50 W start-up)
Rubidium (Rb) oscillator installed: 50 W normal (80 W start-up)
Low-Phase Noise (LPN) Rubidium oscillator installed: 52 W normal (85 W start-up)
Backup Battery: SecureSync has an internal battery to support the Real Time Clock. The
battery is a small recharging lithium coin cell that is not customer-replaceable. This battery
will keep approximate time and date in a shutdown state over ~135 days before requiring
recharge. After full drain, the battery will require ~5 days to fully recharge. Minimum bat-
tery life is ~30+ years.
Hotswap Power Supply: Some SecureSync models have hot-swappable power supplies
and can ensure power redundancy in case of failure. Both power sleds have the same spe-
cifications as the standard AC Power Supply.
1.4 The SecureSync Web UI
SecureSync has an integrated web user interface (referred to as "WebUI" throughout this
documentation) that can be accessed from a computer over a network connection, using a
standard web browser. The WebUI is the most complete way to configure the unit, and for
status monitoring during everyday operation.
Note: If you prefer, an integrated Command-Line Interpreter interface
(CLI) allows the use of a subset of commands.
1.4.1 The Web UI HOME Screen
The HOME screen of the SecureSync web user interface ("Web UI") provides com-
prehensive status information at a glance, including:
vital system information
current status of the references
key performance/accuracy data
major log events.
The HOMEscreen can be accessed from anywhere in the Web UI, using the HOMEbutton
in the Primary Navigation Bar:
The Primary Navigation Bar provides access to all menus:
12
SecureSync 2400 Getting Started Guide Rev. 2
1.4 The SecureSync Web UI
To Next Page
Loading...
Need help?
General
