SecureSync unit
QuickStart Guide (printed version)
Ancillary items (except for rack mounting items, the contents of this kit may vary
based on equipment configuration and/or regional requirements)
Purchased optional equipment (note that option cards listed on the purchase order
will be pre-installed in the unit).
2.4 Required Tools and Parts
Depending on your application and system configuration, the following tools and parts may
be required:
Phillips screwdrivers to install the rack-mount ears, and to mount the unit in a 19"-
rack
Ethernet cables
2.4.1 Required GNSS Antenna Components
Should you plan on using a GNSS reference with your SecureSync, you will also need the
following items (sold separately):
Antenna cable with SMA connector, or conversion cable
Note: The SMA-to-N-type conversion cable included in the ancillary
kit is approved for pull weight of up to 60 lbs. If you are using a heav-
ier cable, you will need to apply appropriate strain relief.
GNSS antenna with mounting bracket
GNSS antenna surge suppressor (recommended)
GNSS antenna inline amplifier (optional for short cable lengths)
2.5 Mounting the Unit
SecureSync units can be operated on a desktop or in a rack in a horizontal, right-side-up
position. The location needs to be well-ventilated, clean and accessible.
18
SecureSync 2400 Getting Started Guide Rev. 2
2.4 Required Tools and Parts
To Next Page
Loading...
Need help?
General
