EPSILON CLOCK MODEL EC20S Spectracom
59 User’s Manual
In this page, the operator can enable/disable the SNMP traps generation and program the Read Only
(RO) and the Read Write (RW) SNMP communities. The SNMP traps report an event (an alarm, the end
of an alarm or a new setup) by sending a trap message.
37. SNMP RO COMMUNITY
Read Only community (for GET SNMP commands). Defaulted to ‘public’.
38. SNMP RW COMMUNITY
Read Write community (for SET SNMP commands). Defaulted to ‘private’. RO and RW
communities will become effective after a software reboot of the EC20S device (see Tools
menu).
39. TRAP COMMUNITY
Trap community (for trap events). Needed to easily identify a family of monitored devices.
Defaulted to ‘public’.
40. IP ADDRESS TRAPS DESTINATION 1
Primary SNMP manager address where traps will be sent. Clear this field to disable the traps
transmission to this address.
41. IP ADDRESS TRAPS DESTINATION 2
Secondary SNMP manager address where EC20S traps will be sent. Clear this field to disable
the traps transmission to this address.
42. GLOBAL TRAPS ENABLE
- Yes Traps are sent according to individual enabling.
- No No trap is generated.
43. EC20S FAULT
- Yes Generates a trap when the EC20S goes on default (according to
"Global Status").
- No No trap is generated.
44. GNSS FAULT
- Yes Generates a trap when the GNSS receiver fails or unlocks
(according to "GNSS Locked").
To Next Page
Loading...