Orolia Spectracom EC20S - Snmp Traps

EPSILON CLOCK MODEL EC20S Spectracom
User’s Manual 92
GNSS CONFIGURATION OID
Description (Ref.)
ec20s-GNSS-CFG-ANTENNA-MODE
78
ec20s-GNSS-CFG-ANTENNA-LATITUDE
79
ec20s-GNSS-CFG-ANTENNA-LONGITUDE
79
ec20s-GNSS-CFG-ANTENNA-ALTITUDE
79
ec20s-GNSS-CFG-GPS-CONSTELLATION-MODE
80
ec20s-GNSS-CFG-GLONASS-CONSTELLATION-MODE
81
ec20s-GNSS-CFG-GALILEO-CONSTELLATION-MODE
82
14.1.3 SNMP TRAPS
Trap events are asynchronous SNMP messages sent by the EC20S upon changes of some configuration
parameters or when an alarm is raised or cancelled. These parameters have an accessible-for-notify
access authenticated by the Trap community (which is defaulted to ‘public’).
Traps are sent by the EC20S to destination addresses which can be set via the “SNMP Setup” web page
or via the SNMP protocol (see 14.1.2 TRAPS CONFIGURATION or 14.1.2 SNMP CONFIGURATION
PARAMETERS).
Traps are sent by the EC20S if the Traps transmission is enabled. The Traps transmission can be
enabled/disabled via the “SNMP Setup” web page. Each trap event can also be enabled/disabled via the
same web page.
Refer to the MIB Description file to get detailed information about each trap (values definition, values
range) under the ‘DESCRIPTION’ section.
TRAP OID
Description (Ref.)
ec20sGeneralHardwareFault
43
ec20sGpsFault
44
ec20sExternalPpsFault
45