Monitor Settings
39
Figure 5.2-14 Output Image Applied with a LUT File
There will a “File format not support!” prompt for unavailable LUT file
when executing file writing operation.
Refer to “6.1.4 Look Tools” for the details about applying the 3D LUT
file.
Make sure your SD card is FAT32 format, otherwise, it will not be
supported in this monitor.
T5+ supports color management software CalMAN currently, the
customized 3D LUT profiles (*.cube) produced by these software
could be loaded to SD card by a control computer.
If detecting no SD card during the operation, it will prompt ”
No
Media
”; if any other wrong happened, it will pop up the relevant
prompt, please check it according to this prompt.
5.2.4 System
The system menu provides monitor info, language selection and factory
reset operations, as shown in Figure 5.2-15:
To Next Page
Loading...
