To Next PageTo Next Page
Need help?Do you have a question about the Otto Bock 3E80 and is the answer not in the manual?
General| Brand | Otto Bock |
|---|---|
| Model | 3E80 |
| Category | Medical Equipment |
| Language | English |
Describes the hydraulic knee joint's electronic control and features.
Lists compatible Ottobock components and states no testing with other manufacturers.
Product is for lower limb prosthetic fittings after transfemoral amputation or knee disarticulation.
Recommends for mobility grades 3-4, up to 125 kg body weight.
Details allowable and unallowable environmental conditions for product use and storage.
States service life is 3-5 years based on 3 million load cycles per ISO 10328.
Explains the meaning of WARNING, CAUTION, and NOTICE symbols used in the document.
Provides general safety advice regarding motor vehicle operation and product strain.
Instructions on how to charge the battery, including precautions.
Details the process for bench alignment using specific tools and measurements.
Describes the static alignment process using the L.A.S.A.R. Posture.
Explains the dynamic trial fitting process, including safety precautions.
Instructions for adjusting flexion and extension damping using an adjustment wrench.
Instructions for adjusting stance phase damping for various situations.
Steps to reset the prosthetic knee joint to its original factory settings.
Explains safety mode activation due to low battery or errors, and its function.
Describes how to switch to and from cycling mode using specific movements.
Details warning signals (vibration, light, audible) for overheating and system faults.
Step-by-step guide to replacing the battery, requiring specific tools.
Manufacturer's liability terms and conditions for product use.
Information regarding product trademarks and brand names.
States the product meets European medical device directive requirements.
