33
Attention!
Regularly checking of the remaining battery capacity and charging of the battery early enough are
indispensable preconditions for the operational safety of your power wheelchair.
Figure 18 Figure 19
10.9 Fuse
The two 60 A fuses are located at the rear end of the battery packs between the battery‘s contacts (Fig. 19).
11 Status and Error Analysis
The following table lists the different error and status messages of the battery indicator and describes the cor-
responding possible causes and solutions. This offers the possibility for yourself to identify and eliminate errors
of the A200. If you do not manage to solve the problem, please contact your dealer.
Indicator Cause Possible solution
Battery indicator flashes slowly Battery is empty Charge as soon as possible
More and more LEDs of the battery Battery charger is connected, Disconnect the battery charger,
indicator begin to flash A200 not ready for driving switch off and on
Battery indicator flashes once every Sleeping mode after longer time
every 2.5 seconds of standstill with the wheelchair
control switched on Switch off and on
Battery indicator flashes quickly Safety-relevant problem, Switch off and on
driving function switched off check plug connections
and that battery voltage is ok
Fast flashing of LED 1 (red) Battery empty or poor Charge the battery or check
connection to the battery the plug connections
Fast flashing of LEDs 1-2 Poor connection
to the left motor Check the motor plug connection
Fast flashing of LEDs 1-3 Short circuit on the left motor Check the motor plug connection
Fast flashing of LEDs 1-4 Poor connection Check the motor plug connection
to the right motor
Fast flashing of LEDs 1-5 Short circuit on the right motor Check the motor plug connection
Fast flashing of LEDs 1-6 Influence by an external signal
(e.g. charging plug) Remove the charging plug
To Next Page