24
During battery charging, the control must be switched off.
For safety reasons, a pelvic belt can be attached, which is optionally available.
Never use a water hose or high-pressure cleaning apparatus for cleaning the wheelchair.
Be careful with your fingers during adjustment and assembly works (risk of injuries).
7 Transport and Storage
The A200 can be transported both as power wheelchair ready to start or in disassembled condition.
7.1 Transport in a Motor Vehicle
During transport the wheelchair must be fully secured by means of tension straps. The frame of the A200 has
four fixing eyelets for the attachment of straps. The temperature during transport and storage must be between
-25°C and +50°C. The wheelchair control must be switched off and the brake engaged during transport.
We recommend whereever and whenever possible, wheelchair users transfer to the seats installed in the motor
vehicle and use the corresponding vehicle restraint systems, because this is the only way to ensure optimal pro-
tection of the passengers in case of an accident. For the time being, Otto Bock has not yet released the A200
Power Wheelchair for use as a seat for transportion in motor vehicles; the release is currently being prepared,
however. You can receive information on the current state of our measures from your authorized dealer or on the
Otto Bock homepage www.ottobock.com.
7.2 Disassembling the A200 Power Wheelchair
To reduce the folding size for transport of the power wheelchair, it can be easily disassembled.
Please observe the following order for disassembly:
1
. Remove the footrests.
2. Loosen the control panel mounting screw, remove the control panel to the rear and deposit it beside the
wheelchair.
3
. Remove the side panels.
4. Fold the backrest down to the front (Fig. 1).
Figure 1 Figure 2
To Next Page
Loading...
